BACKGROUND: Muscle force is important for daily life and sports and can be measured with a handheld dynamometer. Reference values are employed to quantify a subject's muscle force. It is not unambiguous whether reference values can be generalized to other populations. Objectives in this study were; first to confirm the reliability of the utilization of hand-held dynamometers for isometric strength measurement; second to determine reference values for a population of Dutch workers; third to compare these values with those of a USA population.METHODS: 462 Healthy working subjects (259 male, 203 female) were included in this study. Their age ranged from 20 to 60 years with a mean (sd) of 41 (11) years. Muscle force values from elbow flexion and extension, knee flexion and extension, and shoulder abduction were measured with the break method using a MicroFet 2 hand-held dynamometer. Reliability was analyzed by calculating ICC's and limits of agreement. Muscle force expressed in Newton, means, and confidence intervals were determined for males and females in age groups ranging from twenty to sixty years old. Regression equations and explained variances were calculated from weight, height, age, and gender. The mean values and 95% CI were compared to the results from other studies.RESULTS: Reliability was good; the ICC ranged between 0.83 to 0.94. The explained variance ranged from 0.25 to 0.51. Comparison of data for the Dutch population mean muscle force values with those from the USA revealed important differences between muscle force reference values for the American and Dutch populations.CONCLUSIONS: Muscle force measurements demonstrate a sound reliability. Reference values and regressions equations are made available for the Dutch population. Comparison with other studies indicates that reference values differ between countries.
DOCUMENT
Afsluitende brochure van het RAAK-project Op naar beter, nul op de meter! Verschillende auteurs uit het werkveld hebben een bijdrage geleverd. Met een voorwoord van gedeputeerde Nienke Homan.
DOCUMENT
PURPOSE: We hypothesized that the initial rate (first 40 ms) of unilateral knee extensor torque development during a maximally fast isometric contraction would depend on the subjects' ability for fast neural activation and that it would predict bilateral jumping performance. METHODS: Nine males (21.8 +/- 0.9 yr, means +/- SD) performed unilateral fast isometric knee extensions (120 degrees knee angle) without countermovement on a dynamometer and bilateral squat jumps (SJ) and countermovement jumps (CMJ) starting from 90 and 120 degrees knee angles (full extension = 180 degrees ). The dynamometer contractions started either from full relaxation or from an isometric pre-tension (15% maximal isometric torque, Tmax). Torque time integral for the first 40 ms after torque onset (TTI-40, normalized to Tmax) and averaged normalized rectified knee extensor EMG for 40 ms before fast torque onset (EMG-40) were used to quantify initial torque rise and voluntary muscle activation. RESULTS: TTI-40 without pre-tension (range: 0.02-0.19% Tmax per second) was significantly lower than TTI-40 with pre-tension, and both were significantly (r = 0.81 and 0.80) related to EMG-40. During jumping, similar significant positive relations were found between jump height and knee extensor EMG during the first 100 ms of the rise in ground reaction force. There also were significant positive linear relations between dynamometer TTI-40 and jump height (r = 0.75 (SJ 90), 0.84 (SJ 120), 0.76 (CMJ 90), and 0.86 (CMJ 120)) but not between dynamometer Tmax and jump height (-0.16 < r < 0.02). CONCLUSION: One-legged TTI-40 to a large extent explained the variation in jump height. The ability to produce a high efferent neural drive before muscle contraction seemed to dominate performance in both the simple single-joint isometric task and the complex multijoint dynamic task.
DOCUMENT
