The use of H-ZSM-5 with various binders (Al2O3, SiO2, and kaolinite, 10 wt% on catalyst formulation) for the catalytic conversion of glycerol to bio-based aromatics (GTA) was investigated in a continuous bench-scale unit at a pyrolysis temperature of 450 °C, catalytic upgrading temperature of 500 °C, WHSV of pure glycerol of 1 h−1, and atmospheric pressure, and their performance was compared to H-ZSM-5 (SiO2/Al2O3 molar ratio of 28). The latter gave a peak BTX carbon yield of ca. 31.1C.%, a life-time of ca. 220 min, and a total BTX productivity of ca. 312 mg BTX g−1H-ZSM-5. The introduction of binders affects catalyst performance, which is the most profound and promising for the H-ZSM-5/Al2O3 catalyst. It shows a prolonged catalyst life-time of ca. 320 min and a higher total BTX productivity of ca. 518 mg BTX g−1H-ZSM-5, compared to the H-ZSM-5 without a binder. Catalyst characterization studies show that the addition of the binder does not have a major effect on the specific surface area, total pore volume, and total acidity. Other relevant properties were affected, though, such as micropore volume (SiO2), a reduced Brønsted acidity (Al2O3, and SiO2), and reduced crystallinity (SiO2). Coke formation causes severe catalyst deactivation, ultimately leading to an inactive catalyst for BTX formation. Catalyst characterization studies after an oxidative regeneration showed that the textural properties of the regenerated catalysts were close to those of the original catalysts. However, some dealumination of H-ZSM-5 occurs, resulting in decreased crystallinity and acidity, causing irreversible deactivation, which needs attention in future catalyst development studies.
DOCUMENT
The catalytic conversion of glycerol to aromatics (GTA, e.g., benzene, toluene, and xylenes, BTX) over a shaped H-ZSM-5/Al2O3 (60/40 wt%) catalyst was investigated in a continuous fixed-bed reactor to study the addition of the Al2O3 binder in the catalyst formulation on catalyst performance. The experiments were performed under N2 at 550 °C, a WHSV of glycerol (pure) of 1 h−1, and atmospheric pressure. The spent H-ZSM-5/Al2O3 catalysts were reused after an oxidative regeneration at 680 °C and in total 5 reaction-regeneration cycles were performed. Catalyst characterization studies show that the addition of the Al2O3 binder does not affect the surface area and crystallinity of the formulation, but increases the total pore volume (mesopores in particular) and total acidity (Lewis acidity in particular). The H-ZSM-5/Al2O3 (60/40 wt%) catalyst shows a considerably prolonged catalyst life-time (8.5 vs. 6.5 h for H-ZSM-5), resulting in a significant increase in the total BTX productivity (710 vs. 556 mg g−1 H-ZSM-5). Besides, the addition of the Al2O3 binder retards irreversible deactivation. For instance, after 3 regenerations, catalyst performance is comparable to the fresh one. However, after 4 regenerations, some irreversible catalyst deactivation occurs, associated with a reduction in total pore volume, crystallinity, and acidity (Brønsted acidity in particular), and meso-porosity of the Al2O3 binder. This study shows that both the stability and reusability of H-ZSM-5-based catalysts for GTA are remarkably enhanced when using a suitable binder.
DOCUMENT
The catalytic conversion of oleic acid to aromatics (benzene, toluene, and xylenes, BTX) over a granular H-ZSM-5/Al2O3 catalyst (ϕ 1.2–1.8 mm, 10 g loading) was investigated in a continuous bench-scale fixed-bed reactor (10 g oleic acid h–1). A peak carbon yield of aromatics of 27.4% was obtained at a catalyst bed temperature of 550 °C and atmospheric pressure. BTX was the major aromatics formed (peak carbon yield was 22.7%), and a total BTX production of 1000 mg g–1 catalyst was achieved within a catalyst lifetime of 6.5 h for the fresh catalyst. The catalyst was deactivated due to severe coke deposition (ca. 22.1 wt % on the catalyst). The used catalyst was reactivated by an ex situ oxidative regeneration at 680 °C in air for 12 h. The regenerated catalyst was subsequently recycled, and in total, 7 cycles of reaction-regeneration were performed. A gradual decrease in the peak carbon yield of BTX was observed with reaction-regeneration cycles (e.g., to 16.3% for the catalyst regenerated for 6 times). However, the catalyst lifetime was remarkably prolonged (e.g., >24 h), leading to a significantly enhanced total BTX production (e.g., 3000 mg g–1 catalyst in 24 h). The fresh, used, and regenerated catalysts were characterized by N2 and Ar physisorption, XRD, HR-TEM-EDX, 27Al, and 29Si MAS ssNMR, NH3-TPD, TGA, and CHN elemental analysis. Negligible changes in textural properties, crystalline structure, and framework occurred after one reaction-regeneration cycle, except for a slight decrease in acidity. However, dealumination of the H-ZSM-5 framework was observed after 7 cycles of reaction-regeneration, leading to a decrease in microporosity, crystallinity, and acidity. Apparently, these changes are not detrimental for catalyst activity, and actually, the lifetime of the catalyst increases, rationalized by considering that coke formation rates are retarded when the acidity is reduced.
DOCUMENT
A time- and space-resolved deactivation study on the conversion of glycerol to aromatics over H-ZSM-5 was performed. For this purpose, glycerol was vaporized/pyrolyzed in a pyrolysis section followed by a catalytic aromatization step. Benchmark performance showed an induction period of ca. 20 min, followed by a rather constant BTX yield of ca. 25.4 ± 2.2C.% for 3–4 h time on stream (TOS). Subsequently, a rapid drop in BTX yield was observed due to catalyst deactivation. Severe coking leads to coverage of catalyst surface area and blockage of micropores, particularly at the entrance of the catalyst bed at short TOS, indicating the presence of an axial coke gradient in the fixed bed reactor. At longer TOS, coke was formed throughout the bed and negligible BTX yield was shown to be associated with the presence of coke at all bed positions. Besides coking, the acidity of the catalyst was also reduced, and dealumination occurred, both with a similar time–space evolution. The results were explained by a conversion-zone migration model, which includes a deactivation zone (with severely coked catalyst), a conversion zone (BTX formation), and an induction zone (a.o. (de-)alkylation reactions), and describes the time- and space-resolved evolution of coking and relevant changes in other catalyst characteristics.
DOCUMENT
Catalytic pyrolysis of crude glycerol over a shaped H-ZSM-5 zeolite catalyst with (partial) recycling of the product oil was studied with the incentive to improve benzene, toluene, and xylene (BTX) yields. Recycling of the polycyclic aromatic hydrocarbon (PAH) fraction, after separation from BTX by distillation and co-feeding with the crude glycerol feed, was shown to have a positive effect on the BTX yield. Further improvements were achieved by hydrogenation of the PAH fraction using a Ru/C catalyst and hydrogen gas prior to co-pyrolysis, and BTX yields up to 16 wt% on feed were obtained. The concept was also shown to be beneficial to other biomass feeds such as e.g., Kraft lignin, cellulose, and Jatropha oil.
DOCUMENT
Bedoeling van de leerateliers is het vergroten van veiligheid en veerkracht van kwetsbare daders, slachtoffers en belangrijke derden. De pilot is opgezet om een nieuwe vorm van werken bij ZSM te ontwikkelen. Openbaar Ministerie (OM), politie, 3RO, Raad voor de Kinderbescherming (RvdK), Slachtofferhulp Nederland (SHN), en bureau jeugdzorg (BJz), allen vaste partners op ZSM, vormden in Maastricht met Halt, Maatschappelijke organisaties (Moveoo, Vangnet, Levanto) en de William Schrikker Groep (WSG) een team. Er was nauw contact met de Veiligheidshuizen VHH) en Veilig Thuis (VT). Er zijn voor de pilot in Limburg vier doelgroepen geselecteerd: twee daarvan zijn landelijk vastgesteld: 1)jeugdigen, betrokken als dader, slachtoffer of als betrokkene en 2)huiselijk geweld zaken waar kinderen bij betrokken zijn. Limburg heeft daar de volgende doelgroepen aan toegevoegd: - verwarde personen - mensen met een verstandelijke beperking - jong volwassenen In dit beknopte rapport beschrijven we de resultaten van het tweede leeratelier in Limburg in de periode van mei tot juli en de belangrijkste leeropbrengsten en leerpunten die opgespoord zijn. Voordat de werkwijze van het leeratelier Maastricht en de resultaten worden beschreven in hoofdstuk 4, 5 en 6 zullen we eerst toelichten hoe de leerateliers zijn ontstaan en wat de leidende visie is voor de leerateliers (hoofdstuk 2) en wat de vragen zijn waarop de pilots een antwoord moeten geven (in hoofdstuk 3).
DOCUMENT
DOCUMENT
Sustainable production of aromatics, especially benzene, toluene and xylenes (BTX), is essential considering their broad applications and the current global transition away from crude oil utilization. Aromatization of lower olefins, particularly ethene and propene, offers great potential if they are derived from more circular alternative carbon feedstocks such as biomass and waste plastics. This work aims to identify the preferred olefin feed, ethene or propene, for BTX production in a fixed-bed reactor. A commercial H-ZSM-5 (Si/Al = 23) catalyst was used as a reference catalyst, as well as a Ga-ZSM-5 catalyst, prepared by Ga ion-exchange of the H-ZSM-5 catalyst. At 773 K, 1 bar, 45 vol % olefin, 6.75 h−1, propene aromatization over the Ga-ZSM-5 catalyst exhibited higher BTX selectivity of 55 % and resulted in slower catalyst deactivation compared to ethene aromatization.
DOCUMENT
The catalytic coconversion of glycerol and toluene (93/7 wt %) over a technical H-ZSM-5/Al2O3 (60-40 wt %) catalyst was studied, aiming for enhanced production of biobased benzene, toluene, and xylenes (bio-BTX). When using glycerol/toluene cofeed with a mass ratio of 93/7 wt %, a peak BTX carbon yield of 29.7 ± 1.1 C.% (at time on stream (TOS) of 1.5-2.5 h), and an overall BTX carbon yield of 28.7 C.% (during TOS of 8.5 h) were obtained, which are considerably higher than those (19.1 ± 0.4 C.% and 11.0 C.%) for glycerol alone. Synergetic effects when cofeeding toluene on the peak and overall BTX carbon yields were observed and quantified, showing a relative increase of 3.1% and 30.0% for the peak and overall BTX carbon yield (based on the feedstock). These findings indicate that the strategy of cofeeding in situ produced toluene for the conversion of glycerol to aromatics has potential to increase BTX yields. In addition, BTX production on the catalyst (based on the fresh catalyst during the first run for TOS of 8.5 h and without regeneration) is significantly improved to 0.547 ton ton-1catalyst (excluding the 76% of toluene product that is 0.595 ton ton-1catalyst for the recycle in the cofeed) for glycerol/toluene cofeed, which was 0.426 ton ton-1catalyst for glycerol alone. In particular, this self-sufficient toluene product recycling strategy is advantageous for the production and selectivity (relative increase of 84.4% and 43.5% during TOS of 8.5 h) of biobased xylenes.
DOCUMENT
In twee regio’s – Midden-Nederland en Noord-Nederland – is geëxperimenteerd met een bredere reclasseringsinzet op ZSM. De ontwikkeling van een betekenisvolle en contextgerichte aanpak is een belangrijke doelstelling van ZSM. Om deze ontwikkeling goed van de grond te krijgen zijn deze twee pilot-werkplaatsen ingericht. In algemene zin kregen de deelnemende reclasseringswerkers de ruimte en de opdracht om ‘te doen wat nodig is’ en zich daarmee in samenwerking met het OM te richten op betekenisvolle manieren van afdoen en de ontwikkeling van een contextgerichte aanpak. De pilots verliepen in drie fasen. In de eerste fase lag het accent op initieren van nieuwe opties voor een betekenisvolle aanpak en identificeren van belemmeringen om deze aanpak uit te voeren. De tweede fase stond in het teken van uitproberen van nieuwe werkwijzen, die in derde fase uitgebreid en geconsolideerd zijn. In de derde fase is tevens nagedacht over condities bij de inrichting van nieuwe werkplaatsen en voor bredere implementatie van de werkwijze.
DOCUMENT
